Carriage mould

 Grp mould for carriage

Gell, then tissue and 1 ply of csm 



2x3 plies of csm later…



Smelly dirty job… might try the epoxy paste again. Used the one from axson and alchamie in the past but I see that easy composites do one.
We’ll see how this comes out, looks like lots of prerelease but you can see it’s not got too hot which is encouraging so hopefully not too much shrinkage. I’ve used a clear gell so I can see through it, might be helpful if I resin infuse

I’ll leave this for a few weeks to mature and cure before using it but will strip it off the pattern work one evening shortly

Comments

Post a Comment

Popular posts from this blog

Monkey V3 relaunch

Image
  Relaunch of Monkey! Sunday 14 May Got the decals on (from Funky Monkey) and took her out in a nice gentle breeze. Didn't sink and generally all OK   Saturday 20 May Around 20 Knots of breeze, well mannered most of the time but some adjustments needed. Kept luffing up when wind dropped and after tacking. I think it must be unbalanced, jib only 2.1m2. I found in dragonfly with the same daggerboard that 100mm off the bottom worked well. Mast is very soft , perhaps that is also not helping? Chine digging in as well? Work to do: Mast track ate the luff rope so those mast repairs now more urgent (and new bolt rope) I adjusted the kicker but this needs further work Bottom rails of carriage need trimming Dagger board needs shortening Jib track i think needs a stopper as it runs too far out, new jib from HD coming so that will need setting up with that Toe straps are not the right webbing, they are like elastic! Need to source some new material
Read more

Monkey - finishing off (well... sort of )

Image
 Finishing off Monkey…. Well as much as it’s getting before it’s relaunch New shrouds, forestay ext and lowers, cut and shut rudder stock, a bit more rigging.  Seat and carriage back from sprayers and fitted out Trimming foredeck back, real dilemma this. I wanted a long foredeck with the main going right down to it ideally right back to the forward  but it’s a difficult packaging operation. Would work with a gnav but not keen on them. So keeping with a conventional vang and also wanting to be able to run with 150mm to 200mm of board up  Checking daggerboard fits  Still to do…. Mast….   Weight 55Kg, a good result
Read more