Bzzzzz

 Back in 2021….

Got the angle grinder out and started trimming Monkey

Weighing Monkey with no fittings before trimming,34kg

Ready for cutting…..

Decks off


This is the repair I did in Richmond 2014 for Chris Hampe. Rob Bell went through the side…. Just didn’t see each other until it was  to late. You can see in the next photo this all came out so I could rebuild a bit lighter and neater.

Dagger board case out

Fore deck off

Remains of v bulkhead

Left overs

The final state


Comments

Post a Comment

Popular posts from this blog

2024 WORLDS

 2024 Worlds are in Germany as part of Travemunde week. The challenge is to complete Roobard in time, leaving Monkey free for Henry. Henry's not yet sailed a canoe (hes only 14....) but is up for a challenge even if he just races on quiet days. Monkeys seat and carriage is heading for the sprayers next week and im intending to re-launch her April 26th or 29th. There's still a bit to sort out.... rudder, kicking strap, mast, final rigging...... but essentially im now going to be getting her outside and starting on Roobarb.  Taking Friday 14th April as a starting point I have 14 months to put Roobarb together with an intended launch date of June 14th (my birthday). This gives me about a month to iron out any issues before the worlds. There is a bit of a head start already, the stations were machined out and assembled but i do need to set these up correctly before I skin them. The seat and carriage moulds are all sorted out and I have various moulds for the foils. I have secured ...
Read more

Monkey V3 relaunch

Image
  Relaunch of Monkey! Sunday 14 May Got the decals on (from Funky Monkey) and took her out in a nice gentle breeze. Didn't sink and generally all OK   Saturday 20 May Around 20 Knots of breeze, well mannered most of the time but some adjustments needed. Kept luffing up when wind dropped and after tacking. I think it must be unbalanced, jib only 2.1m2. I found in dragonfly with the same daggerboard that 100mm off the bottom worked well. Mast is very soft , perhaps that is also not helping? Chine digging in as well? Work to do: Mast track ate the luff rope so those mast repairs now more urgent (and new bolt rope) I adjusted the kicker but this needs further work Bottom rails of carriage need trimming Dagger board needs shortening Jib track i think needs a stopper as it runs too far out, new jib from HD coming so that will need setting up with that Toe straps are not the right webbing, they are like elastic! Need to source some new material
Read more